TANQ S Moonlight VTX Mount

Let me start by saying: there is no documentation, no photos, no instructions. Nothing. You’re flying blind from the moment you open the bag. No diagrams, no hint of orientation, no mention that the tiny top back VTX screws must be removed for it to even remotely fit. The “nibs” on the bottom? Absolutely useless. I can only assume they’re there as a test of willpower or as an inside joke at the design table.

I ordered this 3D print because the STL file is gatekept like it’s part of a government project, waited a week for shipping, and went in full of hope. The install looks simple — until you realize it’s actually a Rubik’s cube designed by an engineer who hates happiness.

The VTX is fragile, the antenna routing is a pain, and every adjustment feels like defusing a bomb with your bare hands. You finally get everything looking clean… then the top plate refuses to fit. You’ll take it apart, flip the VTX, re-route everything, and stare at it like it just personally insulted you. Still doesn’t fit.

So you watch a video (for an O3, of course), and the guy just casually chops off the mysterious nubs like that’s normal. You follow along, pray to the FPV gods, reassemble everything again, and — surprise! — it still doesn’t work because the top VTX screws hit the plate.

The final step? Remove those screws, squeeze the top plate down like you’re pressing a panini, hold your breath, and finally it clicks together. Two and a half hours later, you’re done. You’ve aged a decade, developed a twitch, and bonded with your drone through shared trauma.

End result? It looks great. But at what cost?

10/10 recommend

Yes, this is ChatGPT but based on a true story Cheers!